The wood chipper is an important wood treatment equipment used to cut wood into uniform sheets. In the use of wood chip machine, you need to pay attention to the following points to ensure the normal operation of the equipment and extend the service life, I hope to help you:
1. The feed of the wood chipper should be strict, and the maximum cutting length should not exceed 2m; The moisture content of cutting raw materials should be 35% to 45%; Small wood diameter class does not exceed 12 cm; The bark content should not exceed 10%, and the harder cork bark wood should be peeled and fed.
2. When starting up, the air feed motor must be started first, and then the main motor must be started. After the knife roller speed is stable, the feeding system can be started to feed the wood chipper.
When stopping, the feeding system must be turned off first, and the main motor can only be turned off when the cutter roller cannot cut the wood. The above order must not be reversed.
3. When the feeding system needs to go backwards, you must press the "Stop" button first, and then press the "back" button after the feeding system stops. When you need to move forward again after going backwards, you must press the "Stop" button first, and then press the "Forward" button. Do not switch between the "forward" and "backward" buttons directly.
4. Tightening the flying knife and the bottom knife must use the torque plate and torque booster that can accurately represent the torque, and tighten according to the specified torque value.
5. The bolts of the flying knife and the bottom knife are specially made high-strength bolts, which can not be replaced by ordinary bolts. Its service life is 1 year, and after 1 year, all must be replaced.
6. The replacement of the flying knife must be replaced in a complete set, and the sharpening amount of the two flying knives should be consistent to ensure the same weight; Coolant must be added when sharpening, otherwise the blade will overheat and burn or produce rolling phenomenon, thus reducing the durability of the blade.
7. Drum wood chipper must work under the working state of hydraulic buffer system, otherwise it will cause vibration of the machine.
8. When the wood chipper is cutting under load, the operator should observe the vibration of the machine and listen to whether there is abnormal sound. If the vibration is large or abnormal, it should be stopped immediately for inspection and elimination.
Proper use and operation of the machine can extend the service life of the machine, if you are interested in TONY wood chipper, welcome to contact us.