During the pelletizing process of the straw pellet machine, due to improper operation or unsuitable raw materials and other issues, problems such as unformed pellets and low output often occur. In this article, TONY will introduce the common troubleshooting methods and solutions for straw pellet machines during the pelletizing process.
Problem point one: The output is too low (or even unformed)
4 reasons |
Elimination method |
1.The first time the ring die was used, the surface finish of the die holes was poor | 1.Continue to use oil-based grinding and lubrication |
2. The moisture content of the material is either too high or too low | 2. Adjust the moisture content of the materials |
3. The gap between the pressure roller and the ring die is too large | 3. Adjust the gap between the pressure roller and the ring die |
4. The pressure roller or ring die is severely worn | 4. Replace. |
Problem point 2: There is too much powder in the pellets
2 reasons | Elimination Method |
1.Low moisture content | 1.Increase the moisture content |
2. The ring die is excessively worn, resulting in a small compression ratio | 2. Replace the new ring die |
During the operation of the straw pellet machine, no matter what kind of raw materials are processed, the above two problem points are often encountered. You can solve them through the description of the editor. Or you can directly connect with our sales engineers. We will handle it for you as soon as possible by phone or video.
For more information on the use of straw pellet machines, please keep following the Shandong straw pellet machine manufacturer - TONY brand. Soon, the editor will bring you the causes and solutions for faults such as rough surface of the pellets, abnormal noise and sudden shutdown during the production process of the straw pellet machine.