Straw pellet machine is a device that compresses the waste of crops such as straw into pellets. The correct operating regulations can not only ensure the stable operation of the equipment, but also ensure the safety of the operator. The following is a detailed correct operating procedure:
1. Preparation work
Equipment inspection: Before installing and debugging, the necessary inspection is required, including whether the equipment parts are intact, whether there is any loss, and whether there are rust and damage. The necessary inspections can effectively reduce operating risks in the installation process.
Selection of the installation location: Make sure the floor level and flat of the installation location are not raised. Outdoor equipment also needs to consider the drainage of low -lying areas.
2. Installation and debugging process
Installation location marking: The installation location logo of the straw pellets is clear, and then fix it according to the supporting drawing operation, connect the power supply, and perform the air load trial operation. Stable work.
Air load trial running: After turning on, take a air rotation for 1-3 minutes. Check whether the machine rotates is normal without abnormal vibration and noise.
3. Preparation before operation
Wearing labor insurance supplies: Before the operator enters the operating area, we should wear labor protection supplies as required. The work clothes should be tightened and buckled with all the buttons, and the hair is pressed in the work cap. Keep in mind the safety precautions and safety warning signs.
Check the connector: Check the tightness of each connector and fastener, and there must be no loose phenomenon; check the power line to ensure that the connection is normal and reliable, and the unit should be effectively grounded.
Pre -processing raw materials: Before the operation, it should be removed by hard debris such as metals, stones, and soil blocks in straw, and pre -processing such as crushing or rubbing as required. The water content of the raw materials shall meet the product standards and instructions requirements.
4. Safety operation
No load operation: Before the operation, it should be turned on without load for 2-3 minutes. It is confirmed that the whole machine is running smoothly, no abnormal vibration, no sound and stagnation, and trial production is based on the production capacity of the machine.
Uniformly feeding: After the machine is operating normally, and the molding straw products meet the requirements, they can be uniform and stable in feeding for continuous production.
Pay attention to safety: During the preheating and production process, the station is strictly prohibited at the disagreement, and it is strictly forbidden to touch the protective cover to avoid burns. Non -staff members are strictly forbidden to enter the operating area.
Surveillance parameters: In the operation, pay attention to whether the readings of voltage meters, current meters, and temperature meters on the control device should be observed in the normal range. When the specified range value is exceeded, it should be stopped to check the reasons and eliminate the failure.
Failure treatment: When abnormal sounds, abnormal vibrations and stagnation phenomena occur during the operation, they should be immediately stopped for inspection to eliminate the failure after the failure.
5. Stop and maintenance
Operation before stopping: Before stopping, you should turn off the heating device, add a moisture content of 25%-40%of the material in the box, and continue to turn off the motor after 2-3 minutes after the production is completed, and turn off the total power supply. , Clean up the operating area.
Cleaning and maintenance: After each job, the straw molding machine should be cleaned and cleaned, the loose parts are tightened, and the lubricating site is lubricated
Long -term storage: When the machine is stored for a long time, it should be stored in a dry and ventilated place in the room after comprehensive maintenance.
Tony reminds you to follow the above operating procedures when using straw pellet machine, which can ensure the efficient and safe operation of the straw pellets and extend the service life of the equipment.