Here are some ways to choose the right wood hammer mill that suits your industry standards.

1. Small Hammer mill - As the screen cloth covers the lower part of the rotor in a semicircle, the small hammer mill is also known as a half-screen hammer mill. The upper body is where the toothed plate is mounted. Raw materials are supplied into the crushing chamber along the tangent line. 

A general type of hammer mill is the little hammer mill. It can adjust to a variety of operating settings. Farms, tiny feed mills, small pellet production lines, and wood processing plants all use small hammer mills 

2. Pneumatic discharge hammer mills (PDHM) - Even though they perform the same functions, the chamber walls and hammers of a pneumatic discharge hammer mill are thinner than those of gravity discharge mills. The plate dashboard at PDHM aids in material size reduction, and the air evacuation procedure utilized for discharge improves total production. This hammer mill is ideal for lightweight materials such as paper, greenwood, biomass, and so on.

3. Full circle screen hammer mills - The 300-degree rotating screen on these industrial hammers helps to improve particle evacuation. They are great for lightweight components that don't need to be ground down beforehand. Spices, grasses, and other materials are hammered in these hammer mills.

This was our take on how you can choose the right pellet machinery or we can say wood hammer mill that suits your needs.

Product Introduction

▶The motor and rotor of this series hammer mill installed on the same base. They are directly connected by coupling. The rotor has been checked by dynamic balance test can rotate in both of forward backward direction.

▶There are symmetrical operation door and safety interlock in both side. The operation doors are helpful to renewal thieve plate and hammers, also helpful for checking up and debugging. Feed inlet is placed in the top of crusher which can be matched with all kind of feed equipment.

▶There is one piece of sieve plate installed at the bottom of wood hammer mill. The size of crushed material could be changed by changing different sieve plate with different hole. Normally, the finished size is from 2mm to 30mm adjustable.

▶Spare parts of hammers and sieve plate are made by our CNC system, through high technical heat treatment.

▶This series hammer mill has reasonable structure, sturdy and durable using, safety and dependable, simple installation, easy operation, tiny vibrating, high efficiency etc. advantages, which is the most ideal grinding equipment of all kinds of wood chips,wood shavings, grass, straw, stalk, corn, weeds, soybean, PVC foaming board, rubber and so on.