Wood pellet machine is a mechanical equipment for processing wood pellets. In order to ensure the normal operation of the equipment and extend the service life, there are many aspects that need to be paid attention to. Shutdown is one of the important aspects and we need to pay attention to it. So, how to stop the Wood pellet machine correctly?

First of all, we need to know that the shutdown sequence is the opposite of the power-on, and the relevant equipment is shut down from front to back according to the process flow. When the base level of the pellet bin to be made shows no material, open the manual feeding door of the pellet machine to observe the feed flow.

Secondly, when the material flow is significantly reduced, the cooler is allowed to manually discharge the material to increase the return flow, so that the material flow at the inlet of thepellet machine increases to ensure the granulation quality. At this moment, you should pay attention to whether the return machine material pipe is blocked. If the return machine material pipe is blocked, stop the cooler manually discharge and open the return machine material. If the return machine material pipe is not blocked, wait to observe the feeding condition of the inlet port.

After discharge of the material in the return pipe, wait a few minutes before putting the material in the cooler, so that there is only a very small amount of return material in the return pipe and reduce pollution to the next production.

In addition, stop steam or moisture supply and stop discharge of the cooler, close the feeder and temperer, then clean the ring mold with oil-containing materials, clean bran or soybeans, and then close the main motor of the pellet machine.

The above is the relevant content of the correct shutdown of the wood pellet machine compiled by the editor for everyone. Do you understand? Hope these contents will be helpful to everyone.