The rational use of biomass pellet machine can not only improve production efficiency, but also extend the service life of the equipment. Here are some key steps and considerations:

1. Preparation before starting

Check the oil circuit: before starting, it is necessary to check whether the refueling machine is normal and whether the oil circuit is smooth to prevent high temperature from burning out bearings and other accessories.

Preheating: Before starting, rotate the rotor by hand to check whether the jaw, hammer and rotor are flexible and reliable, whether there is collision in the shell, whether the rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine, and whether the lubrication of the motor and the pellet machine is good.

Idling test: After starting the crushing table, idling for 2-3 minutes, and then feeding after no abnormal phenomenon.

2. Operation process

Control feeding speed: feeding speed can not be too fast, after about 10 minutes, the body begins to heat up, you can feed at normal speed, otherwise it will lead to blockage and high temperature.

Avoid hard objects: The crushed material should be carefully checked to avoid hard objects such as copper, iron, and stone entering the granulation chamber causing accidents.

Regular inspection: at the end of each shift, the machine will stop after the material in the grain chamber is used, and the dust of the main machine will be cleaned with an air gun, and the shift will be replaced.

3. Maintenance after shutdown

Clean the dust: clean the bag dust collector once per shift, and clean the dust of the host machine with an air gun at the end of each shift.

Lubrication and maintenance: the main reducer of the pellet machine will replace the 220# gear oil for the first 600 hours, and replace it every 4000 hours after the first replacement is completed. The gear oil of the dial reducer and the feeder reducer is replaced once a year; Add hot butter to the coupling of the granulator once a week.

Prevent clogging: Remember to use oil to grind the mold hole before stopping, to avoid the material in the mold will block the mold, resulting in the mold does not discharge, resulting in the generation of boring phenomenon.

4. Precautions

Avoid metal objects: The powder to be processed must not be mixed with any metal objects to prevent damage to the press and ring mold.

Control water content: the water content of the powder to be processed should be about 13-20%, too high affect molding, too low lead to blockage and high temperature, reduce productivity and affect the life of the mold.

Safe operation: When feeding, the operator should stand on the side of the biomass pellet machine to prevent the rebound debris from injuring the face.

Through the above steps and precautions, you can ensure the safe and efficient operation of the biomass pellet machine, while extending the service life of the equipment.