The use and maintenance of the roller group of the wood pellet machines is an important factor affecting the service life of the ring mold and the normal production capacity. Therefore, when using the roller group, you should pay attention to the correct operation of each link. At the same time, when pressing the roller down the press, it should check its wear and do necessary maintenance and maintenance. Pay attention to the following four aspects:

        1. Recharge the transmission part of the pellet machine regularly, lubricate the pressure roller bearing every 2 hours, and lubricate the front bearing of the spindle every 4 hours to ensure the flexible rotation of the transmission part of the pellet machine and reduce the working load.

        2. It is recommended to clean the bearing every 2-5 working days and add high-temperature grease as required by the instructions. If the bearing is found to be loose or locked, the bearing should be replaced or the shaft should be replaced.

        3. When cleaning the roller bearing, it is recommended to remove the bearing and check the appearance records first by taking photos or recording methods. Confirm the amount of remaining grease and sample the grease, and then clean the bearing.

        4. The bearings are coated with an appropriate amount of anti-rust oil and packaged with anti-rust paper. As long as the packaging is not damaged, the quality of the bearing will be guaranteed. However, when stored for a long time, when the humidity in the storage area is less than 65% and the temperature is around 20℃, avoid direct sunlight or contact with cold and humid walls.

        The above are four aspects of the maintenance of the roller group bearing of the wood pellet machine. The specific situation is based on the actual use and maintenance of the pellet machine. It is for your reference only.