Brief description of the granulation process of bamboo pellet machine:

It can be seen from the structure of the pellet machine main machine that the motor drives the ring mold to rotate through the coupling and reducer. The ring mold is installed and rotates on the ring mold seat and rotates with the rotation of the ring mold seat. A pair of press roller assembly is in the horizontal direction, and the raw materials enter the granulation chamber from the feeder. Due to the action of the mixing knife, the raw materials are rubbed and squeezed under the action of the rotation of the ring die and driven the rotation of a pile of pressing roller shells, thereby gradually extruding from the ring die. The columnar object of the press roller foundation rotates as the ring mold turns to the protective cover and is broken, forming pelletized materials of varying lengths and falling into the outlet.

Preparation for starting the bamboo pellet machine and precautions:

Open the feeder observation door to check for any debris such as iron filings. Check all activities to ensure that they are not stuck. Start the feeder and then shut down when the feeder is running at low speed. Before starting the main motor, first check and ensure that all operating components in the biomass pellet forming machine are energy-concentrated and freely operated. Secondly, check and ensure that the ring mold rotates counterclockwise. Then adjust the two pressing rollers so that their surfaces are slightly in contact with the inner surface of the rotating ring mold, and under the action of the ring mold, they can achieve a similar rotation and non-rotation. Try not to let the machine idle for a long time without materials, so as not to cause unnecessary damage to the ring mold and the press roller. Make sure there is enough material in the hopper on the feeder and it flows into the feeder evenly and continuously. When starting the bamboo pellet machine, you should follow the following steps: First, start the bamboo pellet machine and then install the equipment. Start the main motor of the pellet forming machine. Start the feeder motor and control the speed of the feeder motor to resist, so that the material slowly enters the feeder port and ring mold.